Crimp Tool for Stripping Cable RG58 - RG59 - RG62

For stripping RG Cable : RG-58/59/62/6/6QS/3C/4C/5C

Manufacturer No: HT-332

Instructions:

• Stripping Length: This stripper can strip cable in four lengths 4,6,8 and 12mm/ The stripping length is preset to 6mm. If you want to strip other lengths, you may adjust the blade's position.
  
• Blades' Depth: You may use the hex wrench, which is install on the bottom of the tool to adjust the blades' depth. Insert the hex wrench into the blade depth adjuster on the botton of the stripper, then rotate the hex wrench clockwise (to cut larger cable) or counterclockwise (to cut smaller cable).
  
• Stripping Cables:
1. The V-Block is reversible. Use hex wrench to push the V-block out of the housing, align the character on the V-block witht eh arrow, then insert the B-block into its housing. The indicated arrow < recommended the RG cable size mark in front of the V-block. 6=RG6 (5C2V), 8=RG58 (3C2V), 9=RG56/62
2. Press the knurled portion on the upper jaw to open the stripper's jaws.
3. Insert the cable you want to strip through the V-block until the cable reaches the V-shaped cable guide. Then release the upper jaw to close the jaws.
4. Insert your index finger into the stripper's finger ring, turn the stripper clockwise 1-4 times. The cable's insulation is cut while you turn the stripper.
5. Open the jaws and remove the cable. Pull away the outer jacket and dielectric to expose the inner conductor.